GE GFD49GRSKWW Manuel d'utilisateur télécharger pdf (Page 42)

Troubleshooting Tips

Save time and money! Review the charts on the following pages, or visit GEAppliances.com. You may not need to

call for service.

Before you call for service…

GEAppliances.com

Problem Possible Causes What To Do

Dryer shakes or

makes noise

Some shaking/noise is normal.

Dryer may be sitting unevenly.

Move dryer to an even floor space, or adjust leveling legs as necessary

until even.

Clothes take too

long to dry

Improper or obstructed ducting Check the Installation Instructions to make sure the dryer venting is

correct.

Make sure ducting is clean, free of kinks and unobstructed.

Check to see if outside wall damper operates easily.

Improper sorting Separate heavy items from lightweight items (generally, a well-sorted

washer load is a well-sorted dryer load).

Large loads of heavy fabrics

(like beach towels)

Large, heavy fabrics contain more moisture and take longer to dry.

Separate large, heavy fabrics into smaller loads to speed drying time.

Controls improperly set Match control settings to the load you are drying.

Lint filter is full Clean lint filter before every load.

Blown fuses or tripped circuit

breaker

Replace fuses or reset circuit breakers. Since most dryers use 2 fuses/

breakers, make sure both are operating.

Overloading/combining loads Do not put more than one washer load in the dryer at a time.

Underloading If you are drying only one or two items, add a few items to ensure proper

tumbling.

eDry is enabled The eDry feature is designed to operate your dryer in the most

energy efficient mode, which is not always the fastest mode. In some

instances, dry times may be extended to reduce overall energy usage

for the cycle.

The Dry dryness

level was chosen

but load is still

damp

Load consists of a mixture of

heavy and light fabrics

When combining heavy and light fabrics in a load, choose More Dry.

Exhaust system is blocked Inspect and clean exhaust system.

Control buttons

not responding

Controls accidentally put in

service mode

Press Start/Pause.

Controls accidentally put in lock

mode

Hold the Lock Control button for 3 seconds to unlock the dryer.

Controls performed an incorrect

operation

Reset the in-house breaker.

Dryer doesn’t

start

Control panel is “asleep” This is normal. Press Power to activate the control panel.

Dryer is unplugged Make sure the dryer plug is pushed completely into the outlet.

Fuse is blown/circuit breaker is

tripped

Check the building’s fuse/circuit breaker box and replace fuse or reset

breaker. NOTE: Electric dryers use two fuses or breakers.

Dryer was accidentally paused

when starting Delay Dry

If the light on the Start/Pause button is flashing, the dryer is paused. Press

Start/Pause to restart the countdown.

No numbers

displayed during

cycle, only lights

Dryer is continuously

monitoring the amount of

moisture in the clothes

This is normal. When the dryer senses a low level of moisture in the load,

the dryer will display the dry time remaining.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 143 144

Commentaires sur ces manuels

Pas de commentaire

GE GFD49GRSKWW Manuel d'utilisateur Page 42

Commentaires sur ces manuels

Produits connexes et manuels pour Sèche-linge électrique GE GFD49GRSKWW