GE GFD49GRSKWW Manuel d'utilisateur télécharger pdf (Page 43)

Before you call for service…

Problem Possible Causes What To Do

Time Remaining

jumped to a

lower number

The estimated time may change

when a smaller load than usual

is drying

This is normal.

Cannot make a

selection and the

dryer beeps twice

The dryness Level, Temp or

option that you are trying to

select is incompatible with the

chosen dry cycle

This is normal.

Dryer is running

but 00 is

displayed in Time

Remaining

The Ext Tumble option was

chosen

This is normal. During extended tumbling, the time remaining is not

displayed. The extended tumbling option lasts approximately 60 minutes.

Clean Lint Filter

(message)

Power button was activated Press Start/Pause to begin a dry cycle and the message will disappear.

Dryer doesn’t

heat

Fuse is blown/circuit breaker is

tripped; the dryer may tumble

but not heat

Check the building’s fuse/circuit breaker box and replace both fuses or

reset both breakers. Your dryer may tumble if only one fuse is blown or one

breaker tripped.

Gas service is off (gas models

only)

Make sure gas shutoff at dryer and main shutoff are fully open.

LP gas supply tank is empty

or there has been a utility

interruption of natural gas (gas

models only)

Refill or replace tank. Dryer should heat when utility service is restored.

Inconsistent

drying times

Type of heat Drying time will vary according to the type of heat used. If you recently

changed from an electric to a gas (natural or LP) dryer, or vice versa, the

drying time could be different.

Type of load and drying

conditions

The load size, types of fabric, wetness of clothes and the length and

condition of the exhaust system will affect drying times.

Clothes are still

wet and dryer

shut off after a

short time

The door was opened mid-cycle.

The load was then removed

from the dryer and a new load

put in without selecting a new

cycle

A dry cycle must be reselected each time a new load is put in.

Small load When drying 3 items or less, choose Speed Dry or Time Dry.

Load was already dry except for

collars and waistbands

Choose Speed Dry or Time Dry to dry damp collars and waistbands. In the

future, when drying a load with collars and waistbands, choose More Dry.

Dryer is not level Move dryer to an even floor space or adjust leveling legs as necessary until

even.

Clothes are

wrinkled

Overdrying Select a shorter drying time.

Remove items while they still hold a slight amount of moisture. Select a

Less Dry or Damp setting.

Letting items sit in dryer after

cycle ends

Remove items when cycle ends and fold or hang immediately, or use the

Ext Tumble option.

Overloading Separate large loads into smaller ones.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 143 144

Commentaires sur ces manuels

Pas de commentaire

GE GFD49GRSKWW Manuel d'utilisateur Page 43

Commentaires sur ces manuels

Produits connexes et manuels pour Sèche-linge électrique GE GFD49GRSKWW