GE CSA1201RSS Manuel d'instructions Page 17

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 48
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 16
Snip all 4 webs
on each knockout
panel and remove
the metal knockouts
for rear airflow.
Locate the two “knockout” plates, on the rear oven
panel, near the top of the oven.
Using tin snips, carefully cut the web area from the
two holes side-by-side (that secure the knockouts to
the oven). Cut all four webs on both rear knockouts;
this will allow the ventilation fan airflow to exhaust
out the rear of the oven.
CAUTION:Be sure to trim the sharp
edges from the openings after removing the
knockout plates.
AFTER: Fan Blade
Openings Facing
Back
7
Place the blower unit back into the opening.
9
Insert the tabs on each side of the damper
into the holes at the inside rear of the adaptor.
8
Roll the blower unit 90° so that fan blade openings
a
re facing out the back of the oven.
5
17
Blower Plate
Replace the blower plate in the same position
a
s before with the screws.
Before Rolling
After Rolling
Back of Oven
End A
End B
Back of
Oven
Back of
Oven
CAUTION:Do not pull or stretch
the blower unit wiring. Make sure the wires
are not pinched.
NOTE: The blower unit exhaust openings should
match exhaust openings on rear of oven.
Installation Instructions
Blower Plate Screws
Oven Rear Panel
6
Attach the exhaust adaptor to the rear of the oven
by sliding it into the guides at the top center of the
back of the oven.
10
Secure the exhaust adaptor to the oven with
the two bronze metal screws provided.
11
Push in securely until it is in the lower locking tabs.
Take care to assure the damper hinge is installed
so that it is at the top and that the damper swings
freely.
Slide exhaust
adaptor into
guides on
oven rear.
Exhaust Adaptor
Damper
(hinge side up)
Locking
Tabs
Guides
Back of Oven
Exhaust
Adaptor
Screws
Vue de la page 16
1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 47 48

Commentaires sur ces manuels

Pas de commentaire