Ge 45132 GE Choice Alert Motion Sensor Manuel d'utilisateur télécharger pdf (Page 12)

Motion Sensor F.A.Q.’S

Q. I bought a new Sensor and the Control Center will

not recognize it. Why?

A. First, make sure that the battery is new and has

been correctly attached to the terminals. Conﬁrm that

the Sensor has been correctly assigned to a Zone.

Q. I put the Sensor on Zone 4 and it will not set off the

alarm. Why?

A. Zone 4 is a Dedicated Alert Zone and is designed

to monitor Sensors in this Zone. It will only issue an

alert (LED will ﬂash, continuous beeping will be heard).

Sensors in Zone 4 will not set off the alarm. Use Zone

4 for water Sensors, garage doors, gates, sheds or

other areas you want to monitor (i.e. areas you want

to be alerted if there is a problem, but do not want the

alarm to sound).

Q. I erased a Sensor from a Zone and now all of my

other Sensors in that Zone will not work. Why?

A. The system can only erase entire Zones. You will

need to add the other Sensors back in that Zone to the

Control Center again.

Q. I put the Sensor in a Zone (1, 2, 3) and it will not

sound in any Alert modes. Why?

A. The Motion Sensor only functions as an Alarm

Sensor in Zones 1, 2, 3. It will not activate a chime,

visual or audio alert. An Alert in Zone 4 only, but will

not activate the alarm.

Q. How can I tell if the Sensor is working?

A. Each Sensor has an LED that indicates the Sensor

is operating (ﬂashes when triggered). However if

the battery is to weak, the signal may not reach the

1 2 ... 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Ge 45132 GE Choice Alert Motion Sensor Manuel d'utilisateur Page 12