GE C2S980 Manuel d'utilisateur Page 55

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 64
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 54
55
G
EAppliances.com
Problem Possible Causes What To Do
Oven not clean after Oven controls not properly set. See the Using the self-cleaning oven section.
a clean cycle
Oven was heavily soiled. Clean up heavy spillovers before starting the clean cycle.
Heavily soiled ovens may need to self-clean again or
for a longer period of time.
LOCK DOOR flashes The self-clean cycle has been Close the oven door.
in the display selected but the door is not
closed.
LOCKED DOOR light The oven door is locked Touch the CLEAR/OFF pad. Allow the oven to cool.
is on when you want because the temperature
to cook inside the oven has not
dropped below the
locking temperature.
F—and a number or You have a function error code. Touch the CLEAR/OFF pad. Allow the oven to cool for
letter flash in the display one hour. Put the oven back into operation.
If the function code repeats. Disconnect all power to the range for 5 minutes and
then reconnect power. If the function error code
repeats, call for service.
Probe” appears in This is reminding you to enter Enter a probe temperature.
the display a probe temperature after
plugging in the probe.
Display goes blank A fuse in your home may be Replace the fuse or reset the circuit breaker.
blown or the circuit breaker
tripped.
The clock is in the See the Special features of your oven control section.
black-out mode.
Display flashes Power failure. Reset the clock.
Unable to get the Oven control pads were The BAKE and BROIL HI/LO pads must be touched at
display to show “SF” not pressed properly. the same time and held for 3 seconds.
Power outage, Power outage or surge. Reset the clock. If the oven was in use, you must reset
clock flashes it by touching the CLEAR/OFF pad, setting the clock
and resetting any cooking function.
Burning or “oily This is normal in a new oven To speed the process, set a self-clean cycle for a
odor emitting from and will disappear in time. minimum of 3 hours. See the Using the self-cleaning
the vent oven section.
Strong odor An odor from the insulation This is temporary.
around the inside of the oven
is normal for the first few times
the oven is used.
LOC appears in The Gas/Control Lockout feature Be sure the surface burner controls are turned OFF.
the display is activated. Turn this feature off to use the range. See the
Gas/Control Lockout section.
Consumer SupportOperating InstructionsSafety Instructions
Installation
Instructions
Troubleshooting Tips
Vue de la page 54
1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 63 64

Commentaires sur ces manuels

Pas de commentaire