GE GDT226SSLSS Manuel du propriétaire télécharger pdf (Page 11)

49-55124-1 11

Care and cleaning

CARE AND CLEANING

Filter Assembly

Inspect and clean the filters periodically. This should be done every month or more depending on usage. If there is a

decrease in wash performance or dishes feel gritty, this is also an indication the filters need to be cleaned.

Protect Against Freezing

If your dishwasher is left in an unheated place during the

winter, ask a service technician to:

Turn off electrical power to the dishwasher. Remove

fuses or trip circuit breaker.

Turn off the water supply and disconnect the water inlet

line from the water valve.

Drain water from the water inlet line and water valve.

(Use a pan to catch the water.)

Reconnect the water inlet line to the water valve.

Does Your Dishwasher Have an Air Gap?

An air gap protects your dishwasher

against water backing up into it if a drain

clogs. The air gap is not a part of the

dishwasher. It is not covered by your

warranty. Not all plumbing codes require

air gaps, so you may not have one.

The air gap is easy to clean.

Turn off the dishwasher and lift off the air gap cover.

Remove the plastic cap under the cover and clean with a

toothpick.

Replace the cap and cover when the air gap is clean.

Check the air gap any

time your dishwasher

isn’t draining well.

Air gap

To clean the filter assembly, remove the bottom

rack and lower spray arm. Twist the filter assembly

counterclockwise and lift to remove. Remove the filter

plate.

Rinse the filters with warm soapy water. Scouring pads

or brushes can scratch the filter surfaces but a soft brush

or sponge may be needed to remove stubborn soils or

calcium deposits caused by hard water.

Once cleaned, replace the filter plate, insert the filter

assembly through the plate and twist it clockwise until

it locks in place. Make sure the filters are fully seated

as improper replacement of the filters may reduce the

performance level of the appliance. Replace the lower

spray arm and lower rack.

Filter

Plate

Filter Assembly

Lower

Spray Arm

Stainless Steel Inner Door and Tub

The stainless steel used to make the dishwasher tub and

inner door provides the highest reliability available in a

GE Appliances dishwasher.

If the dishwasher tub or inner door should be scratched

or dented during normal use, they will not rust or

corrode. These surface blemishes will not affect their

function or durability.

Twist

counterclockwise

and lift to remove

Replace the filter plate.

Snap the fine filter back

into the coarse filter.

Place filter assembly

through the filter plate

and twist clockwise to

lock into the dishwasher

Press tabs on

the fine filter

and pull to

separate from

the coarse filter

Fine Filter

Coarse Filter

Filter Plate

IMPORTANT: Before replacing, make sure no objects have

fallen into the opening in the bottom of the dishwasher.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 47 48

Commentaires sur ces manuels

Pas de commentaire

GE GDT226SSLSS Manuel du propriétaire Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Lave-vaisselle GE GDT226SSLSS