Ge UPVH890 Manuel d'utilisateur télécharger pdf (Page 30)

WARNING – NEVER LEAVE

THE BACK OPENING WITHOUT THE PLATE.

(Kit WE1M454)

Dryer Exhaust to the bottom of cabinet

for Gas and Electric models.

BOTTOM VENTING (cont.)

Connect standard metal elbows and ducts to

complete the exhaust system. Cover back opening

with a plate (Kit WE1M454) available from your

local service provider. Place dryer in final location.

ADDING COVER PLATE TO REAR OF CABINET

(BOTTOM EXHAUST)

Plate

(Kit WE1M454)

EXHAUSTING THE DRYER (cont.)

Installation Instructions

ADDING A NEW DUCT

• Reconnect the cut

portion A of the

duct to the blower

housing.

• Tape the elbow

in a 90-degree

position to

prevent rotation.

• Insert the elbow

through the rear hole

and connect it to

portion A. Rotate

the elbow through

the bottom opening.

• While holding down

the pipe and elbow, using

your hand through the rear

opening, drill a 1/8″ hole

through the bottom tab

hole and the pipe as

shown in the illustration.

NOTE: Make sure the hole is drilled all the way

through the elbow and pipe.

CAUTION: Be sure not to pull

or damage the electrical wires inside the dryer

when inserting the duct.

• While still holding down

the pipe and elbow from

the rear opening, screw

the pipes in place with

the previously saved screw.

• Apply duct tape

as shown on the joint

between the dryer internal

duct and the elbow.

NOTE: Make sure the tape

covers the screw hole in

portion A where it connects

to the elbow.

CAUTION: Internal duct joints

must be secured with tape; otherwise, they may

separate and cause a safety hazard.

Duct tape

Rear hole

Bottom

opening

Bottom view

Portion “A”

Fixing hole

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 151 152

Commentaires sur ces manuels

Pas de commentaire

Ge UPVH890 Manuel d'utilisateur Page 30

Commentaires sur ces manuels

Produits connexes et manuels pour Séchoirs Ge UPVH890