Ge CGS990SETSS Manuel d'utilisateur télécharger pdf (Page 38)

Installation

Instructions

Range

If you have questions, call 1.800.GE.CARES or visit our website at GEAppHances.com

In the Commonwealth of Massachusetts

• This product must be installed by a licensed plumber or

gas fitter.

• When using ball type gas shut-off valves, they shall be

the T-handle type.

• A flexible gas connector, when used, must not exceed 3 feet.

BEFORE YOU BEGIN

Read these instructions completely and carefully.

Installation of this range must conform with local

codes or, in the absence of local codes, with the

National Fuel Gas Code, ANSI Z223.1/NFPA.5A, latest

edition. In Canada, installation must conform with

the current Natural Gas Installation Code, CAN/

CGA-B1A9.1 or the current Propane Installation

Code, CAN/CGA-B1A9.2, and with local codes where

applicable. This range has been design-certified by

CSA International according to ANSI Z21.1, latest

edition, and Canadian Gas Association according to

CAN/CGA-1.1 latest edition.

As with any appliance using gas and generating heat,

there are certain safety precautions you should follow.

You will find these precautions in the Important Safety

Information section in the front of this manual. Read

them carefully.

IMPORTANT ~ Save these instructions for

local electrical inspector's use.

IMPORTANT ~ observe all governing

codes and ordinances.

Not© to Installer - Leave these instructions with

the appliance after installation is completed.

Note to Consumer - Keep this Owner's Manual

and Installation Instructions for future reference.

Note - This appliance must be properly grounded.

Servicer - The electrical diagram is in on envelope

attached to the bock of the range.

Proper installation is the responsibility of the installer.

Product failure due to improper installation is not

covered under the Warranty.

Mobile Home - Additional Installation Requirements

The installation of this range must conform to the

Manufactured Home Construction and Safety Standard,

Title 24 CFR, Port 3280 (formerly the Federal Standard

for Mobile Home Construction, use the Standard for

Manufactured Home Installations, ANSI A225,1/NFPA

501A or with local codes.

Mobile home installations require:

• When this range is installed in a mobile home, it must

be secured to the floor during transit. Any method of

securing the range is adequate os long os it conforms

to the standards listed above.

FOR YOUR SAFETY

Do not store or use combustible materials, gasoline or

other flammable vapors and liquids in the vicinity of

this or any other appliance.

If you smell gas:

O Open windows.

Q Don't touch electrical switches.

Q Extinguish any open flame.

Q Immediately coll your gas supplier.

MATERIALS YOU MAY NEED

• Gas line shut-off valve

• Pipe-joint sealant or UL-opproved pipe thread tope with

Teflon* that resists action of natural and LP gases

• Flexible metal appliance connector (1/2" I.D.) A 5-foot

length is recommended for ease of installation but other

lengths ore acceptable. Never use on old connector when

installing a new range.

• Flore union adopter for connection to gas supply line (3/4"

or l/2"NPTxl/2" I.D.)

• Flore union adopter for connection to pressure regulator on

range (1/2" NPTx 1/2" I.D.)

• Liquid leak detector or soapy water.

• Log bolt or 1/2" O.D. sleeve anchor (for concrete floors only).

*Teflon: Registered trademark of DuPont

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 113 114

Commentaires sur ces manuels

Pas de commentaire

Ge CGS990SETSS Manuel d'utilisateur Page 38

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la maison Ge CGS990SETSS