Ge 21029 Manuel d'utilisateur télécharger pdf (Page 51)

• Check for a dial tone.

You experience static, noise, or fading in and out

• The handset may be out of range of the base. Move closer to base.

• Make sure base is not plugged into an electrical outlet with another household

appliance. If necessary, relocate the base.

• Charge the battery (for 16 hours).

Unit beeps

• Clean the charging contacts on the cordless handset.

• See solutions for “No dial tone”.

• Replace the battery.

Memory dialing doesn’t work

• Did you program the memory location keys correctly?

• Did you follow proper dialing sequence?

Unit locks up and no communication between the base and cordless handset

• Unplug the power supply from the electrical outlet and the back of the base.

Remove the handset battery. Wait for 30 seconds and plug the power supply back

into the base and electrical outlet. Reconnect the battery and charge for 16 hours.

Handset displays “

SEARCHING” or “OUT OF RANGE” and cannot link up with the

base when TALK/END/call back button is pressed.

• Handset may be out of range from the base. Move closer to the base.

• Make sure the power supply is properly installed.

• Disconnect the handset battery and plug it again. Place the handset on the cradle

for at least 2 to 3 minutes.

• Disconnect the power supply and plug it in again. Then place the handset on the

cradle for at least 2 to 3 minutes.

Handset displays HANDSET NEEDS REGISTRATION

• Follow the programming in the telephone procedures to re-register the handset

to the base.

• Press the mute/prog key to start the registration and follow

the procedure.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 115 116

Pas de commentaire

Ge 21029 Manuel d'utilisateur Page 51