Ge GBC12IAX Manuel d'utilisateur télécharger pdf (Page 16)

Installation Instructions

LOCATING THE ANTI-TIP

FLOOR BRACKET (CONT.)

Preferred Installation – Wood

Preferred Installation –

Concrete

Minimum Acceptable #1 –

Wall Plate Stud

Minimum Acceptable #2 –

Wood Floor

Minimum Acceptable #3 –

Concrete Floor

Figure 2 – Acceptable Screw Placement

Locations

CONCRETE Wall and Floor Construction:

• Anchors required (not provided):

4 each 1/4″ x 1 1/2″ lag bolts

4 each 1/2″ O.D. sleeve anchors

• Drill the recommended size holes

for the anchors into the concrete at the

center of the holes marked in Step 2.

• Install the sleeve anchors into the drilled

holes. Place the anti-tip floor bracket as

indicated in Step 2. Remove the locator

template from the floor.

• Install the lag bolts through the anti-tip floor

bracket and tighten appropriately.

WOOD Wall and TILE Floor Construction:

• For this special case, locate the 2 wall holes

identified in Fig. 1. Drill an angled 1/8″ pilot

hole (approx. as shown in Fig. 3) in the center

of each hole.

• Mount the anti-tip floor bracket using

the Minimum Acceptable Installation #1,

as illustrated in Fig. 2.

ANTI-TIP BRACKET INSTALLATION

WOOD Wall and Floor Construction:

• Drill the appropriate number of 1/8″ pilot

holes in the center of each floor bracket hole

being used (a nail or awl may be used if a drill

is not available) AND remove the locator

template from the floor.

• Mount the anti-tip floor bracket by fastening

the 2, or preferably 4, #10-16 hex-head

screws tightly into place as illustrated in

Figure 3.

POSITIONING THE REFRIGERATOR

TO ENGAGE THE ANTI-TIP FLOOR

BRACKETS

Before pushing the refrigerator into

the opening, plug the power cord into

the receptacle and connect waterline

(if equipped). Check for leaks.

Locate the refrigerator’s RH side and move

back approximately in line with the RH side

of the cabinet opening, W. This should position

the anti-tip floor bracket to engage the anti-tip

locator hole in the back of the refrigerator.

Gently roll the refrigerator back into

the cabinet opening until it comes

to a complete stop. Check to see if

the refrigerator front lines up with the cabinet

front face. If not, carefully rock the refrigerator

forward and backward until engagement

occurs and you notice that the refrigerator

is fully pushed up against the rear wall.

OPTIONAL: Adjust the front leveling leg to fully

engage the rear anti-tip brackets, while also

aligning the refrigerator front with the cabinet

front face.

Figure 3 – Attachment to

Wall and Floor

NOTE:

If you pull the refrigerator out and away from the wall

for any reason, make sure the anti-tip floor bracket is

engaged when the refrigerator is pushed back against

the rear wall.

Rear RH Corner of

the Refrigerator

Floor

Wall

Plate

Stud

Floor

Bracket

2 Screws Must

Enter Wood or

Metal Stud

Wall

INSTALLING THE ANTI-TIP FLOOR BRACKET (cont.)

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 67 68

Commentaires sur ces manuels

Pas de commentaire

Ge GBC12IAX Manuel d'utilisateur Page 16

Commentaires sur ces manuels

Produits connexes et manuels pour Réfrigérateurs Ge GBC12IAX