Ge CT918STSS Manuel d'utilisateur télécharger pdf (Page 23)

Care and cleaning of the oven. GEAppliances.com

Be sure electrical power is off and all surfaces are cool before cleaning any part of the oven.

How to Remove Protective Shipping Film and Packaging Tape

Carefully grasp a corner of the protective

shipping film with your fingers and slowly peel

it from the appliance surface. Do not use any

sharp items to remove the film. Remove all of

the film before using the appliance for the first

time.

To assure no damage is done to the finish

of the product, the safest way to remove

the adhesive from packaging tape on new

appliances is an application of a household

liquid dishwashing detergent. Apply with a soft

cloth and allow to soak.

NOTE: The adhesive must be removed from all

parts. It cannot be removed if it is baked on.

Oven Light Bulb Replacement

To remove:

Turn the glass cover counterclockwise

1/4 turn until the tabs of the glass cover

clear the grooves of the socket. Wearing

latex gloves may offer a better grip.

Using gloves or a dry cloth, remove the

bulb by pulling it straight out.

IMPORTANT: Remove the bulb to

determine the kind needed as a

replacement.

To replace:

Replace the bulb with the same type of

bulb that was removed. Your model will

have one of the three types shown.

For appliance bulb, use a new 40-watt

appliance bulb. A 40-watt appliance

bulb is smaller than a standard 40-watt

household bulb.

For halogen bulbs, use a new 120/130-

volt halogen bulb, not to exceed 50 watts.

Determine the correct replacement bulb

by checking the bulb terminals. Bulbs

with 2 straight pin terminals are G6.35

bulbs. Bulbs with 2 looped terminals are

G9 bulbs. (Do not interchange.) Be sure

the replacement bulb is rated 120 volts

or 130 volts (NOT 12 volts).

Using gloves or a dry cloth, remove the

bulb from its packaging. Do not touch the

bulb with bare fingers. Oil from skin will

damage the bulb and shorten its life.

Push the bulb straight into the receptacle

all the way.

Place the tabs of the glass cover into

the grooves of the socket. Turn the glass

cover clockwise 1/4 turn.

For improved lighting inside the oven,

clean the glass cover frequently using a

wet cloth. This should be done when the

oven is completely cool.

Reconnect electrical power to the oven.

Bulb

Socket

Tab

Maximum

length

ø2”(7.6 cm)

Glass cover

Shock or Burn Hazard: Before replacing oven light bulb, disconnect the electrical power to the

oven at the main fuse or circuit breaker panel. Failure to do so may result in electric shock or burn.

BURN HAZARD: The glass cover and bulb should be removed when cool. Touching hot glass with

bare hands or a damp cloth can cause burns.

WARNING

CAUTION

Glass cover

Socket

Receptacle

Tab

G9 Bulb

Socket

Receptacle

Tab

G6.35

Bulb

Receptacle

Use gloves

or cloth

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 67 68

Commentaires sur ces manuels

Pas de commentaire

Ge CT918STSS Manuel d'utilisateur Page 23

Commentaires sur ces manuels

Produits connexes et manuels pour Poêles Ge CT918STSS