GE JGBP38 Manuel d'utilisateur télécharger pdf (Page 47)

CONVERTING TO LP GAS (Standard Twin Burner models only)

or Converting Back to Natural Gas from LP

HOW TO CONVERT A STANDARD TWIN

BURNER RANGE FOR USE WITH LP GAS OR

NATURAL GAS

This range leaves the factory set for use with natural

gas. If you convert to LP gas, keep these instructions

and orifices in case you want to convert back to

natural gas.

The conversion should be done by a qualified

technician or installer.

PREPARE RANGE FOR CONVERSION

(1) Turn off gas supply at the wall.

(2) Turn off the electrical power to the range.

If range has not yet been connected to gas supply,

or if flexible connection was made, range may be

pulled out from the wall to make conversion

easier.

CONVERT THE PRESSURE REGULATOR

1. Remove the cooktop and locate the pressure

regulator at right rear of the range.

2. Follow the directions in box

or that

match your regulator type.

CBA

WARNING: Do not remove the pressure

regulator from the range.

If It Is This Regulator:

1. Use a coin to remove the cap from the

pressure regulator.

2. Turn the cap over and hook it into the slots.

The type of gas to be used should now be visible

on the top of the cap.

Gas Flow

into Range

Lever shown

closed.

PULL TO OPEN.

NAT

Cap

TOOLS REQUIRED:

Adjustable wrench

1/2″ open-end wrench

Flat blade screwdriver (small)

Nut drivers: 7mm, 5/16″ or a small adjustable

(depending on the size of the spuds)

If It Is This Regulator:

1. Unscrew the plastic-protected hex-nut cap

from the regulator.

2. Carefully pry the protective plastic cap off

the threaded metal cap. Gently pull the plastic

washer off the threads on the other side of the

metal cap.

3. Push the plastic cap onto the end of the metal

cap displaying the type of gas you are converting

to. Press the attached plastic washer onto the

threads on the other side of the metal cap.

4. Screw the hex-nut cap back into the regulator.

Do not overtighten.

If It Is This Regulator:

1. Use an adjustable

wrench to remove the

nut from the pressure

regulator.

2. Apply sideward

finger pressure to

remove the plastic pin

from the nut.

HINT: To remove the

pin, place the nut on

a flat surface and press

the pin sideways with

your fingers.

3. Push down on the disc edges to replace the

pin in the nut.

4. Reinsert the

assembly into the

regulator.

NAT

NAT LP

(Standing pilot models do

not have a gas shut-off

valve on the regulator.)

Converter

nut and pin

Gas Flow into

Range

NAT

Cap Assembly

Lever shown

closed. PULL

TO OPEN.

Do not remove

this protective

cap except for

conversion.

(continued next page)

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 55 56

Commentaires sur ces manuels

Pas de commentaire

GE JGBP38 Manuel d'utilisateur Page 47

Commentaires sur ces manuels

Produits connexes et manuels pour Poêles GE JGBP38