GE PT878GC Manuel d'utilisateur télécharger pdf (Page 96)

Programming Site Data 4-35

April 2004

Entering General-Purpose Analog Inputs (cont.)

2. The next prompt asks you to create a label for the input. The

label corresponds to the measurement type (i.e., velocity or

temperature), while the units symbol corresponds to the

measurement units (i.e., feet/sec or degrees F).

a. Press

[ENTER] to open the text creation window, which

appears similar to Figure 4-16 below.

Figure 4-16: The Text Creation Window

b. Use the four arrow keys to scroll to the desired letter or

symbol, and press

[ENTER] to add the letter to the label.

Note: Pressing

[SEL] causes the screen to alternate between a

set of upper-case (capital) letters, a set of lower-case

letters, and a set of symbols. Use all three screens to

create a desired label.

c. Repeat this procedure for each letter or symbol you wish to

add to the label. If you wish to delete a letter, press

[F1]

(Delete) to erase each letter or symbol, from right to left on

the label. (The label window can display up to 14

characters.)

d. When you have completed the label, press

[F3] (OK) to

confirm the label, or

[F2] (Cancel) to leave the window

without adding the label.

A B C D E F G H I J

K L M N O P Q R S T

U V W X Y Z 0 1 2 3

4 5 6 7 8 9 . , “ ‘

= < >

Delete

Cancel

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 307 308

Pas de commentaire

GE PT878GC Manuel d'utilisateur Page 96