GE JV936DSS Manuel d'instructions télécharger pdf (Page 17)

Installation Instructions

7 INSTALL MOTOR 9 INSTALL DUCT COVERS

To install the 12 duct cover alone:

• Place the 12 section of the decorative duct cover on

top of the hood.

• Secure the cover to the top of the hood with 4 screws

provided.

To install the 2-piece duct cover:

• Place the 2-piece duct cover on top of the hood.

• Secure the bottom cover to the top of the hood with

4 screws provided. See illustration, page 16.

• Extend the inside section upwards to meet the

ceiling and ceiling bracket.

• Secure the duct cover to the bracket with the 2 small

Phillips screws provided.

8 CONNECT ELECTRICAL

Verify that power is turned off at the source.

WARNING: If house wiring is not 2-wire

with a ground wire, a ground must be provided by the

installer. When house wiring is aluminum, be sure to

use U.L. approved anti-oxidant compound and

aluminum-to-copper connectors.

Motor Attachment Bracket

Motor Hooks

Install 2 Screws

Insert Tabs Into Slots

• Secure the support to the hood with screws as shown.

10 INSTALL FILTER SUPPORT

• Tip filter support into the rear of the hood.

• Insert support tabs into the slots at the rear of

the hood.

• Plug the motor connector into

the mating hood connector. See

the illustration for the hood

connector location. Touch the

hood to locate and make the

connection.

IMPORTANT: Hold the

connector so the two square

corner terminals are at the top as you

position the connector to plug it in.

• Align and engage the

slots in the blower

assembly to the 3 hooks

at the rear of the

exhaust opening.

• Rotate motor upwards

until it aligns with the

attachment screw

location.

• Secure the motor to

attachment bracket

at the front of the

opening with washer

and screw provided.

• Use wire nuts to connect incoming ground to green,

white to white and black to black.

• Push wires into junction box and replace cover.

Be sure wires are not pinched.

White

Ground

Black

Check That White, Black and

Green Hood Wires Are Threaded

Thru Small Hole in Bracket

Remove

Junction Box

Cover

Insert Power

Conduit Thru

Strain Relief

and Tighten

Use UL Listed Wire Nuts

″

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Commentaires sur ces manuels

Pas de commentaire

GE JV936DSS Manuel d'instructions Page 17

Commentaires sur ces manuels

Produits connexes et manuels pour Hottes de cuisine GE JV936DSS