GE JGBP31 P Manuel d'utilisateur télécharger pdf (Page 45)

—

❑

CONVERTING SURFACE BURNERS ON

MODELS EQUIPPED WITH SEALED BURNERS (See

Step 4 if

range

is equipped with dual burners.)

Burner Cap

Burner Head

Q

<

i

.

a

1. Remove grates, burner caps and burner heads.

2. Remove burner bases by unscrewing the 3

small screws in each base.

~

burner

straight out.

DO

N~

disconnect the wires from the burner

bases unless the

cooktop needs to be raised.

3. Remove the brass orifice spud under each

burner base by unscrewing spud from fitting with

7mm

or 5/16” wrench (depending on the size of

your spuds).

Apply a 3/4” wrench to the hex

on

the

gas inlet tube as a back-up when

removing spud to prevent the aluminum

tube

horn

twisting.

4. Install orifice spuds

accordin to one of the

d

following diagrams (see ❑ or B ), for LP

gas or natural gas, depending on which you are

converting to.

❑

Orifice Spuds for

Convetiingto

LPGas:

LP orifice spuds are in a small plastic bag packed

with this Use and Care book.

LP or~lce spuds

have a 2-digit number and the Letter “L” on

one side. Each orifice spud will also have 1 or 2

grooves on one side, denoting the location on

the range where it is to be installed.

❑

Orifice Spuds for

Convetiingto

NaturaI

Gas:

Natural gas or~lce spuds have a 3-digit number

on one side. Each

otilce

spud will also have 1, 2

or 3 grooves on one side, denoting the location

on the range where it is to be installed.

(continued next page)

45

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 51 52

Commentaires sur ces manuels

Pas de commentaire