GE GDT635HSMSS Manuel d'installation télécharger pdf (Page 14)

Dishwasher Installation

DISHWASHER WET TEST

• Turn on power supply or plug power cord into outlet,

if equipped.

• Select a cycle to run and push the Start/Reset pad.

• Ensure the door is latched. Dishwasher should start.

• Check to be sure that water enters the dishwasher.

If water does not enter the dishwasher, check to be

sure that water and power are turned on.

• Check for leaks under the dishwasher. If a leak

is found, turn off power at the breaker, and then

tighten water connections. Restore power after leak

is corrected.

• Check for leaks around the door. A leak around

the door could be caused by door rubbing or

hitting against adjacent cabinets. Reposition the

dishwasher if necessary. See Step 12.

• Press and hold the Start/Reset pad for 3 seconds to

cancel the cycle. The unit will begin to drain. Check

drain lines. If leaks are found, turn off power at the

breaker and correct plumbing as necessary. Restore

power after corrections are made. See Steps 6, 7, 8,

9 and 16.

• Open dishwasher door and make sure all of the

water has drained. If not, check that disposer plug

has been removed and/or air gap is not plugged.

Also check drain hose to be sure it is not kinked

underneath or behind dishwasher. See Step 16.

• Press Start/Reset pad once again and run

dishwasher through another cycle. Check for leaks and

correct if required.

• Repeat these steps as necessary.

POSITION SOUND

BARRIER AND INSULATION

(on some models)

Skip this step if the sound barrier is assembled

to the dishwasher.

• Locate the sound insulation package inside the

dishwasher.

• Locate the control box.

• Apply the insulation to the underside of the control

box and flush with its front face as shown.

Insulation shown correctly placed along the bottom

edge of the control box, the dishwasher bottom and

flush with the front face.

If the insulation has an extension piece (on

some models) follow these additional steps:

• Open door all the way, if the door doesn’t stay fully

open, adjust the insulation panel.

• Align the screw holes with the screw holes on the

legs of the dishwasher.

• Ensure vent opening is not blocked by insulation.

STEP 19 STEP 20

Control

Box

Junction Box

Cover

(on some models)

Junction Box

Cover

Vent opening should be properly

aligned with cutout in the insulation

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

GE GDT635HSMSS Manuel d'installation Page 14

Commentaires sur ces manuels

Produits connexes et manuels pour Lave-vaisselle GE GDT635HSMSS