Ge DCL333 Manuel d'utilisateur télécharger pdf (Page 10)

Using the four shipping carton corner posts

(two on each side), carefully lay the dryer on its

left side and remove foam shipping pad.

CAUTION:

To prevent damage, do not use the

control panel as a means to pick up or move

the dryer.

Return the dryer to an upright position.

Adjust the leveling legs to match the washer

height. The dryer must be level and rest firmly

on all four leveling legs.

Preparing to install your dryer.

Read these instructions completely and carefully.

Customer Service Troubleshooting Tips

Operating Instructions

Safety InstructionsInstallation InstructionsCustomer Service Troubleshooting Tips Installation Instructions Safety Instructions

Operating Instructions

Customer Service Troubleshooting Tips Installation Instructions Safety Instructions

Operating Instructions

WARNING

■ This dryer must be exhausted to the outdoors

using only rigid metal or flexible metal 4″

diameter ductwork for inside the dryer cabinet

or exhausting.

■

Never use plastic or other combustible ductwork.

See Exhausting section.

■ This appliance must be properly grounded

and installed as described in these

Installation

Instructions.

■ Do not install or store appliance in an area where

it will be exposed to water/weather. See

Location

of Your Dryer

section.

■ The National Fuel Gas code restricts installations

gas appliances

in garages. They must be 18″

(45.7 cm) off the ground and protected from

vehicles by a barrier. See

Location of Your Dryer

section.

■ The

electrical service

to the dryer must conform

with local codes and ordinances and the latest

edition of the National Electrical Code,

ANSI/NFPA 70.

■ The

gas service

to the dryer must conform with

local codes and ordinances or the latest edition of

the National Fuel Gas Code ANSI Z223.1.The gas

dryer is designed under ANSI Z 21.5.1 for

home

use only

. This dryer is not recommended for

commercial applications such as restaurants or

beauty salons, etc.

Unpacking the Dryer

Foam shipping pad

Packing

■ Phillips head screwdriver

■ Channel-lock adjustable pliers

■ Carpenter’s level

■ Flat or straight blade screwdriver

■ Duct tape

■ Rigid or flexible metal 4″ (10.2cm) duct

■ Vent hood

■ Pipe thread sealer (

GAS DRYER

)

■ Plastic knife

■ 1/2″ open-end wrench

Tools and Materials Required for Dryer Installation

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

Ge DCL333 Manuel d'utilisateur Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Séchoirs Ge DCL333