Ge DHDVH66 Manuel d'utilisateur télécharger pdf (Page 21)

1. Remove the Dryer

Leveling Legs

A. Carefully lay the dryer on its side.

Use the packing material so you

don’t scratch the finish on the dryer.

B. Use an open-end wrench or pliers

to remove the dryer leveling legs.

INSTALLING THE STACK BRACKET KIT

Back out and remove

all 4 leveling legs

2. Install Rubber Pads

to Dryer Base

Locate the 4 rubber pads in the parts

package. Remove the adhesive backing

and firmly place over on the bracket

where you removed the leveling legs.

3. Install Bracket

to Dryer

A. Align the holes in the left bracket

with the holes in the bottom left

corner of the dryer. Use a Phillips

screwdriver to install the 2 #12 x 1″

tapping screws.

B. Repeat the above step with the right

bracket on the bottom right corner

of the dryer.

C. Set the dryer upright.

NOTE: Make sure to set the dryer

on a piece of packing material so

the brackets that are attached to

the bottom of the dryer do not damage

the floor.

ge.com

Consumer Support

Troubleshooting TipsOperating InstructionsSafety Instructions

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 55 56

Pas de commentaire

Ge DHDVH66 Manuel d'utilisateur Page 21