Ge CGS990SETSS Manuel d'utilisateur télécharger pdf (Page 25)

Remove and replace full extension racks, (on some models) GEAppliances.com

ACAUTION

To avoid burns, place the racks in the correct position before turning on the oven.

Make sure frame is fully inserted in the oven to lock it in place.

Extension Rack

when placing and removing cookware, always

pull the rock out by its upper front roil to its

fully open position.

NOTE: Do not extend the rack quickly. Food

may slide off the front of the rack.

To remove the rock:

Make sure the rack is pushed all the way into

the oven so that the side paddles on the rack

frame disengages with the oven support.

Firmly grasp the rack handle and pull towards

you. The rack will stop when the curved end of

the rack hits the oven bump.

Tilt the front end up and pull it out.

NOTE; When handling the extension rack, do

not allow the sliding portion to fall open. This

can damage the slides.

To replace the rack:

m Firmly grasp both sides of the rack frame

and the sliding rack.

Place the curved end of the rack onto the

desired rack position, tilt up the front of the

rack and push it in as far as it will go.

I When the rack is properly installed and locked

into position, the locking side paddles on the

rack frame will click-lock into place on the oven

supports. If the side paddles did not click-lock

into position, repeat the steps above and make

sure the side paddles have been correctly

cleaned and lubricated. See

Extension Rack in

the Care and cleaning section.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 113 114

Pas de commentaire

Ge CGS990SETSS Manuel d'utilisateur Page 25