Ge CGS990SETSS Manuel d'utilisateur télécharger pdf (Page 35)

GEAppliances.com

Oven Racks

All oven racks may be cleaned by hand with an

abrasive cleaner or steel wool. After cleaning,

rinse the racks with clean water and dry with a

clean cloth. Gray porcelain-coated oven racks

may remain in the oven during the self-cleaning

cycle without being damaged. The nickel-plated

oven racks may remain in the oven during the

self-cleaning cycle, but they will lose their luster

and become hard to slide. It will be necessary

to grease all oven rack side edges with a light

coating of vegetable oil after cleaning them by

hand or in the oven. This will help maintain the

ease of sliding the racks in and out of the oven.

Extension Rack

Extension racks may be cleaned by hand with

an abrasive cleaner or steel wool. During

cleaning, be careful not to allow water or

cleaner to enter the extension slides on the

sides of the rack.

NOTE: Do not clean in a dishwasher.

The rack may also remain in the oven during

the self-cleaning cycle without being damaged.

(Not applicable for nickel extension racks.)

If the rack becomes hard to remove or

replace, wipe the oven rack supports with

cooking oil. Do not wipe cooking oil on the

slides.

If the rack becomes difficult to slide or if the

paddle is difficult to actuate, the rack may need

to be lubricated using the Graphite Lubrication

shipped with your oven. To order additional

Graphite Lubrication, call our National Parts

Center at

800.626.2002 and reference

WB02T10303.

Rack right-side-up

m

To lubricate the slides:

NOTE: Do not spray extension rack with cooking

spray or other lubricant sprays.

Remove the rack from the oven. See

Extension Rack in the Using the oven

section.

Fully extend the rack on a table or

countertop. Newspaper may be placed

underneath the rack for easy cleanup.

If there is debris in the slide tracks, wipe it

away using a paper towel.

NOTE: Any graphite lubricant wiped away

must be replaced - see steps 4 through 7.

Shake the graphite lubricant before

opening it. Starting with the left slide

mechanism of the rack, place four (4)

small drops of lubricant on the two (2)

bottom tracks of the slide close to the

bearing carriers.

Repeat for the right slide mechanism of

the rack.

s

Open and close the rack several times to

distribute the lubricant.

Replace the cap on the lubricant and

shake it again. Turn the rack over and

repeat steps 3,4,5 and 6.

Close the rack, turn rack right-side-up and

place in the oven. See Extension Rack in

the Using the oven section.

To lubricate the paddle:

Shake lubricant and

apply to the moving

ports of the paddle

mechanisms as shown.

35

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 113 114

Commentaires sur ces manuels

Pas de commentaire