GE JCS57 Manuel d'utilisateur télécharger pdf (Page 32)

●

QUESmONS?

USE THIS PROBLEM SOLVER

PROBLEM

POSS~LE CAUSE

OWN WLL

● The plug on the range is not completely inserted in the electrical outlet.

NOT WORK

● The circuit breaker in your house has been tripped, or a fuse has been blown.

● The oven controls are not properly set.

OVEN LIGHT

cThe fightbulb is loose or defective. Tighten or replace.

DOES NOT WORK

● The switch operating the oven light is broken. Call for service.

FOOD DOES NOT

● The OVEN SET knob not set at BROIL.

BRO~ PROPE~Y

● The OVEN TEMP knob not set at BROIL.

● Door not left open to the broil stop position as recommended.

● Improper sheE position being used. See the Broiling Guide.

● Food is being cooked on hot pan.

● Cookware not suited for broiling.

● Murninum foil used on the broiler pan and rack has not been fhted properly

and slit as recommended.

FOOD DOES NOT

ROAST OR BAKE

PROPERLY

OVEN ~LL NOT

SELF-CLEAN

(model JCP67)

OVEN NOT CLEAN

AFTER CLEAN CYCLE

(model JCP67)

AUTOMA~C OVEN

~ER DOES NOT

WORK PROPERLY

SURFACE LIGHT

DOES NOT WORK

SURFACE UNITS

NOT FUNCTIOMNG

● The OVEN SET knob not set on BAKE.

● The OVEN TEMP knob not set correctly.

● Shelf position is incorrect.

ckcorrect cookware or cookware of improper size is being used.

● A foil tent was not used when needed to slow down browning during roasting.

● Automatic timer dids not set or not set properly.The clock must be set

to time of day and the STOP dial must be set and advanced beyond the

time noted on the oven clock.

● The STOP dial was not advanced for long enough.

● Both the OVEN SET and the OVEN TE~ knobs must be set at CLEAN settings.

● When the oven is seti-cleaned, a thick pile of spillover can leave a heavy

layer of ash and insulate that area from further heat.

● The oven controls are not set properly.

● Heavily soiled ovens rquire 31/2-to4-hour clean time.

“Heavy spillovers should be cleaned up before starting the clean cycle.

● Check to be certain step by step directions were followed correctly.

See the Automatic Timer and Clock section.

● The fluorescent light is loose or defective. Adjust or replace.

● Press the switch for 2 seconds. If the light does not come on, repeat.

● The switch operating the light is broken. Call for service.

● The surface units are not plugged in sofidly.

● The surface unit controls are not properly set.

Myou need more help.. cdl, toll free

The

GE Answer Centerm

800.626.2000

consumer information service

1 2 ... 27 28 29 30 31 32 33 34 35 36

Commentaires sur ces manuels

Pas de commentaire

GE JCS57 Manuel d'utilisateur Page 32

Commentaires sur ces manuels

Produits connexes et manuels pour Fours GE JCS57