GE JG5P38 Manuel d'utilisateur télécharger pdf (Page 43)

❑

LEVELING THE

RANGE

1. Remove the storage

drawer, broiler drawer or

kick panel.

2. Use a 3/16” open-end

or socket wrench to back

out both rear leveling legs

approximately two turns.

3. Use a

1:%”

open-end or

adjustable wrench to back

out the front leveling legs

two turns.

4. Install the oven shelves

in the oven and position

the range where it will be installed.

5. Check for levelness by placing a spirit level or

a cup, partially filled with water, on one of the

oven racks. If using a spirit level, take two

readings—with the level placed diagonally first

in one direction and then the other.

6. Adjust the leveling legs until the range is level.

7. After the range is level, slide the range away

from the wall so that the Anti-Tip device can be

installed.

INSTALLING

THE

ANT[.T[P

DEVICE

W_ING:

Range must be secured with an approved

Anti-Tip device.

● Unless properly installed, the range could

be tipped by you or a child standing, sitting

or leaning on an open door.

●

After installing the Anti-Tip device,

veri&

that it is in place by carefully attempting to

tilt the range forward.

● This range has been designed to meet all

recognized industry tip standards for all

normal conditions.

● The use of this device does not preclude

tipping of the range when not properly

installed.

●

If the Anti-Tip device supplied with the

range does not fit this application, use the

universal Anti-Tip device

~02X7909.

Mark the wall where the HGHT EDGE of the

range

is to be located. Be sure to

allow

for the

cou~tertop

overhang if you intend to install the

range next to cabinets.

hcate

the outside edge of the device 2%”

toward the center of the range from the marked

edge of the range.

3. Using the device as a template, mark the

position of the hole for the screw.

4. For wood construction, drill a pilot hole at an

angle of 20 degrees from the horizontal. A nail

or awl maybe used if a drill is not available.

Mount the Anti-Tip device with the screw

provided.

For cement or concrete construction, you

will need a 1/4” x

1%”

lag bolt and a 1/2”

O.D.

sleeve anchor, which are not provided. Drill

the recommended size hole for the hardware.

Install the sleeve anchor into the drilled hole

and then install the lag bolt through the device.

The bolts must be properly tightened as

recommended for the hardware.

5. Slide the range against the wall, and check

for proper installation by grasping the front

edges of the rear surface unit openings and

carefully attempting to tilt the range forward.

WHEN ALL HOOKUPS ARE COMPLETED:

MAKE SURE ALL CONTROLS ARE LEFT IN THE

OFF POSITION.

MAKE SURE THE FLOW OF COMBUSTION AND

VENTIUTION

TO THE RANGE IS

UNOBSTRU~ED.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 53 54

Commentaires sur ces manuels

Pas de commentaire

GE JG5P38 Manuel d'utilisateur Page 43

Commentaires sur ces manuels

Produits connexes et manuels pour Cuisiniers GE JG5P38