GE JG5P38 Manuel d'utilisateur télécharger pdf (Page 44)

HOW TO CONVERT THE RANGE FOR USE

WITH

GAS OR NATURAL GAS

This range leaves the factory set for use with

natural gas.

you convert to

gas, keep these

instructions and

orflces

in case you want to

convert back to natural gas.

TOOLS REQUIRED:

T-10

Torxdriver

(for sealed burners)

1/2” and 3/4” open-end wrench

Flat blade screwdriver (small)

Nut drivers or wrenches:

7mm,

5/16” or a small

adjustable (depending on the size of the spuds)

❑

PREPARE RANGE FOR CONVERSION

(1) Turn off gas supply at the wall.

(2) Turn off the electrical power to the range.

If range has not yet been connected to gas supply,

or if flexible connection was made, range maybe

pulled out from the wall to make conversion easier.

❑

CONVERT THE PRESSURE

REGUUTOR

W~~G:

Do not remove the pressure

regulator from the range.

1. For models equipped with sealed burners,

remove the storage drawer, broiler drawer or

kick panel and locate the pressure regulator at

rear of the range.

)

Remove Screws

Access Cover

On some models, you may have to remove an

access cover also.

For models equipped with

stindard

twin

burners, remove the

cooktop

and locate the

pressure regulator at right rear of range.

❑ n

2. Follow the directions in

or B that match

your regulator type.

❑

Standard Twin Burner Models

(models with lift-up

cooktop)

NAT

—

Cap

Flow

Range

closed.

OPEN,

If it is this regulator:

1. Use a coin to remove the cap from the

pressure regulator.

2. Turn the cap over and hook it into the slots.

The type of gas to be used should now be visible

on the top of the cap.

❑

Sealed Burner Models

(models without lift-up

cooktop)

-ever shown closed

except

for conversion

If it is this regulator:

Unscrew the plastic-protected hex-nut cap

from the regulator.

2. Carefully pry the protective plastic cap off

the threaded metal cap. Gently pull the plastic

washer off the threads on the other side of the

metal cap.

3. Push the plastic cap onto the end of the metal

cap displaying the type of gas you are converting

to. Press the attached plastic washer onto the

threads on the other side of the metal cap.

4. Screw the hex-nut cap back into the regulator.

Do not overtighten.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 53 54

Commentaires sur ces manuels

Pas de commentaire

GE JG5P38 Manuel d'utilisateur Page 44

Commentaires sur ces manuels

Produits connexes et manuels pour Cuisiniers GE JG5P38