GE JG5P38 Manuel d'utilisateur Page 49

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 54
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 48
PROBLEM
“F- AND A NUMBER”
FLASH
IN
THE DISPLAY
OVEN WILL NOT WORK
TOP BURNERS DO NOT
LIGHT OR DO NOT
BURN EVENLY
BURNERS HAVE YELLOW
-
OR YELLOW-TIPPED
~AMES
BURNER FLAMES VERY
LARGE OR YELLOW
SURFACE BURNERS
LIGHT BUT OVEN
DOES
NOT
SURFACE LIGHT DOES
NOT WORK
POSSIBLE CAUSE
*
If the
time
display flashed
“F-
and
a
number”, you have a function error code.
If function error code appears
during
the
self-cleaning cycle, check oven door
latch. The latch handle may have been moved, even if
only
slightly, from the
latched position. Make sure the latch
is
moved to
the
right as far as
it
will go.
Press the
CLEAWOFF pad.
Allow
the oven to cool for one hour.
Rt
the oven
back into operation. If the failure code repeats, disconnect all power to the
range. Call for service.
*
Plug on range is not completely inserted
in
the electrical outlet.
The circuit breaker in your
house has been tripped, or a fuse has been blown.
Oven controls not properly set.
Door left in locked position after cleaning.
Make sure electrical plug is plugged into a live power outlet,
Burner holes on the side or
around
the top of burner may be clogged. Remove
burners (on models with standard twin burners) or
burner
heads (on models
with sealed burners) or burner caps on spill-proof models, and
clean
them
with a sewing needle or twist tie. Make sure
you
do not enlarge the
holes.
On
spill-proof models, check electrode area
for
burned-on food
or
grease.
(A) Yellow
flarnes—
(B)
Yellow
tips on outer
(C)
Soft
blue
flare+
Call
for
service
cone%Normal
for
LP
gas
Normal for natural gas
If burner flames look Me
(A),
cdl for service. Normal burner
flames
should look
like (B) or (C), depending on the type of gas you use.
*
With
LP
gas,
some yellow tipping
on
outer cones is normal.
If range is connected to
LP
gas, check
dl
steps in the Installation Instructions.
The oven gas shut off valve may have accidentally been moved during
cleaning or moving.
To check the oven gas shut off valve
on
standard twin
burner
models,
raise
the
cooktop
and
Iook
for
the
gas shut off lever at the extreme right rear corner.
To
check
the oven gas shut off valve
on
sealed burner models, remove the
storage drawer, broiler drawer or kick panel and look for the gas shut off
lever at the back of the range. On some models you may have to remove
an access
cover
also.
Fluorescent bulb is loose or defective. Adjust or replace.
* Switch operating the light is broken. Call for service.
(continued next page)
49
Vue de la page 48
1 2 ... 44 45 46 47 48 49 50 51 52 53 54

Commentaires sur ces manuels

Pas de commentaire