GE PFDS450 Manuel d'utilisateur télécharger pdf (Page 35)

REMOVE THE DOOR ASSEMBLY

Remove the side hinge cap by opening the dryer

door and removing the screw from behind the

hinge (#8 x .375” tapping screw). Then using your

hand, pop the hinge cap off the dryer.

Hinge

cap

DISASSEMBLE THE DOOR ASSEMBLY

Turn the door assembly over and separate the

chrome cover from the inner door. Put the inner

door aside on a soft, protected flat surface.

Lay the door down on a soft, protected, flat surface

so that the inner part faces upward (door resting on

the handle side).

Remove the 7 screws (#10 x 1.125” tapping screws)

located around the perimeter of the door.

7 x A Screws

Installation Instructions

BEFORE YOU START

Unplug the dryer from its electrical outlet.

REMOVE THE DOOR ASSEMBLY (cont.)

Close and hold the door, remove the 2 hinge screws

(#10 x 0.75” tapping screws). Pull the door away

from the dryer front panel.

2 x B

Screws

1 x C Screw

REVERSING THE DOOR SWING (if desired)

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 155 156

Pas de commentaire

GE PFDS450 Manuel d'utilisateur Page 35