GE RGA620 Manuel d'utilisateur Page 28

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 40
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 27
Skip to Step 4 if conversion is not necessary.
This range leaves the factory set for use with natural
gas. When converting to LP gas, keep these
instructions in case you need to convert back to
natural gas.
WARNING: This conversion must be
made by a qualified installer or gas supplier in
accordance with the manufacturer’s instructions
and all codes and requirements of the authority
having jurisdiction. Failure to follow instructions
could result in serious injury or property damage.
The qualified agency performing this work
assumes responsibility for the conversion.
Tools Required:
Adjustable wrench
1/2 open-end wrench
Phillips-head screwdriver
Flat-bladed screwdriver (blade width
approximately 3/32 across)
5/16 nutdriver or small adjustable wrench
Prepare Range for Conversion:
1. Turn off the gas supply to the range.
2. Turn off electrical power to the range.
If the range has not yet been connected to the gas supply,
or if a flexible connection was made, the range may be
pulled out from the wall to make the conversion easier.
CAUTION: If the gas supply to range is disconnected
for any reason, see the installation instructions for
proper connection and safety precautions.
Convert the Pressure Regulator:
WARNING:Do not remove the pressure
regulator from the range.
1. Lift the cooktop, prop it open and locate the
pressure regulator at the left rear of the range.
2. Use a large, flat-bladed screwdriver or a coin to
remove the cap from the pressure regulator.
3. Turn the cap over and hook it into the slots.
The type of gas to be used should now be
visible in the center of the cap.
Consumer Support Troubleshooting Tips Installation Instructions Care and Cleaning Operating Instructions Safety Instructions
28
Installation of the range.
Read these instructions completely and carefully.
Converting the Range for Use with LP (Propane) Gas (if necessary)
Burner Specifications:
Top Burner Orifice Drill Size Marking
Natural Gas #53 (.0590 dia.) N
LP (Propane) #66 (.0330 dia.) L
LP Gas spud is marked
with an “L”
Natural Gas spud is
marked with an “N”
Gas flow
into range
Lever shown closed.
Pull to open.
Oven only shut-off.
Gas flow
into range
Lever shown closed.
Pull to open.
Oven only shut-off.
Natural gas cap
(marked with “NAT”)
LP gas cap
(marked with “LP”)
Vue de la page 27
1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 39 40

Commentaires sur ces manuels

Pas de commentaire