GE MN-ValVue-v2-8-IOM Manuel de service télécharger pdf (Page 480)

100

101

ValVue Digital Communications Software Ver. 2.80

480

GE Oil & Gas

Buttons and Fields

Hart Master

Master Mode Use the pulldown list to select the HART mode as either:

 Primary: This the default

 Secondary

This is the HART Master mode used by the VECTOR when communicating as a HART

master with wired-HART devices.

Retry Count Enter the number of retries to establish communication before failure.

Device Scan Mode

Sub-Device Scan On

Power-up

Use the pulldown list to enable or disable scans automatically on powerup.

When enabled, the VECTOR scans the 4-20 mA loop for attached HART devices on

power-up or when the VECTOR is reset. These devices are added to the list of sup-

ported sub-devices for the VECTOR and are communicated to the WirelessHART

gateway.

The VECTOR can support a maximum of eight sub-devices. If more than eight

wired-HART devices are detected, only the first eight devices are used.

Scan Start Address Enter the start address for the scan.

Scan Start Address Enter the stop address for the scan.

Sub-Device Time

Sync

Use the pulldown list to set so that when you scan you synchronize the subdevice

times with the scanning device.

Polling Address Enter the address. This is the HART polling address used to communicate to the VEC-

TOR on the wired-HART interface using a HART capable host (such as a HART com-

municator or PC with HART modem).

By default, the VECTOR is at HART polling address 15. Range: 0 and 63.

1 2 ... 475 476 477 478 479 480 481 482 483 484 485 ... 659 660

Commentaires sur ces manuels

Pas de commentaire

GE MN-ValVue-v2-8-IOM Manuel de service Page 480

Commentaires sur ces manuels

Produits connexes et manuels pour Mesure, test et contrôle GE MN-ValVue-v2-8-IOM