GE MN-ValVue-v2-8-IOM Manuel de service télécharger pdf (Page 491)

100

101

491

Configure Event Notification Tab

Configure

Buttons and Fields

Event Message

Number

Use the pulldown to select a number between 0 and 8 or 0 and 3 (depends on the

number of event messages supported). This number can then optionally be linked to

the Subdevice Tag and is linked to parameters configured on the remaining three

tabs.

Status button Click to open the Event Status Subtab dialog where you view and clear

notifications.

Subdevice Tag Use the pulldown list to select a tag to which you link the Event Message Number.

Mode Use the pulldown to select either Enabled or Off for the configured Event Message

Number.

Event Timing

Retry Time Enter the number of seconds to wait before a retry.

Debounce Interval Enter a time in seconds for which a debounce interval is enforced before a second

event for the message number is allowed. The debounce interval is the minimum

time period over which the bit must remain changed (i.e., the time the event must

persist) in a device before the event notification is sent. If the this interval does not

conform to the allowed values the device adjusts them accordingly and returns the

corrected values.

Max. Update Time Enter a number of seconds, which is the maximum time beyond which the software

must check to see if the configured parameters have been matched.

1 2 ... 486 487 488 489 490 491 492 493 494 495 496 ... 659 660

Commentaires sur ces manuels

Pas de commentaire

GE MN-ValVue-v2-8-IOM Manuel de service Page 491

Commentaires sur ces manuels

Produits connexes et manuels pour Mesure, test et contrôle GE MN-ValVue-v2-8-IOM