search

GE MN-ValVue-v2-8-IOM Manuel de service Page 531

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 660
  • Table des matières
  • DEPANNAGE
    •
  • MARQUE LIVRES
    • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 530
531
Status
Read Controller PID Displays the process controller PID parameters: P, I, Kt , Kd, and
Beta. Available only in version 5.11 and higher.
Read Setpoint Scale Displays the controller setpoint scale. Available only in version 5.11
and higher.
Response
The HART command response from the HDLT is displayed in the response box.
Status Code List
The following status messages report events since the last time the status codes were
cleared.
Startup – The level was powered off and restarted or a reset occurred.
Sensor Disconnected – The sensor was disconnected.
Sensor Fault – An invalid sensor reading was detected.
Torque Sensor Error – An invalid sensor reading was detected.
TCIR Reference Error – An invalid internal reference voltage was detected.
Torque Sensor Range Error – The torque sensor measurement was out of range.
EEProm Write Error – An attempt to save data to the non-volatile memory failed.
Data Overrun Error – An internal software/hardware error occurred.
Timeout Error – An internal software/hardware error occurred.
Circuit Temperature Error – The circuit temperature was outside of the operating
range.
Circuit Temperature Sensor Error – An invalid temperature sensor measurement was
detected.
Software Error – An internal software/hardware error occurred.
No Refresh – An internal software/hardware error occurred.
LOW ALARM – The level is lower than the lower alarm setting.
HIGH ALARM – The level is higher than the upper alarm setting.
Displacer Height Error – The displacer position was out of range.
Mounting Error – The level head is mounted incorrectly (compared to calibration and
configuration settings).
Specific Gravity Out of Range – The measured specific gravity is out of range.
Displacer Error – An invalid displacer measurement was detected.
Calibrate Failed – Calibration failed, probably due to an invalid data entry.
Low Alarm Occurred – The level was lower than the lower alarm setting (but may be
above the limit currently).
Vue de la page 530
1 2 ... 526 527 528 529 530 531 532 533 534 535 536 ... 659 660

Commentaires sur ces manuels

Pas de commentaire
Produits connexes et manuels pour Mesure, test et contrôle GE MN-ValVue-v2-8-IOM
Mesure, test et contrôle GE PT878 Manuel d'utilisateur   (297 pages)
Mesure, test et contrôle GE EPM 5300 Manuel d'utilisateur   (100 pages)
Mesure, test et contrôle GE PK91627 Manuel d'utilisateur    (68 pages)
  • CENTURY PRODUCTS Cablecon Moma Ultraguard Ringer
  • Netgear Ordinateurs portables de poche Silvercrest Micro-ondes Prestigio Cadres photo numériques Globalsat Chargeurs d'appareils mobiles Lexicon Lecteurs de DVD
  • Sony ICF-SW1000T Xavax Melina LG IPS236V-PN HP ProDesk 600 G3 Base Model Microtower PC Keyence CZ-V1
  • LG CM4420 Manuel de l'utilisateur Lg M4210LCBA Manuel de l'utilisateur Horizon Fitness T40 Schéma de câblage HP Pavilion 25xw 25-inch IPS LED Backlit Monitor Manuel de l'utilisateur Sony CDX-GT260MP Manuel de l'utilisateur