GE MN-ValVue-v2-8-IOM Manuel de service télécharger pdf (Page 57)

100

101

Advanced Setup with

ValVue

Methods to Set Up the SVI II AP

There are two methods of setting up the SVI II AP with ValVue:

1. Run Setup Wizard from the Monitor screen.

2. Advanced Setup of the SVI II AP by and advanced user.

The Setup Wizard automatically runs through the specified setup routines and is executed from

the Monitor screen. The Setup Wizard is the preferred and recommended method for initializing

an SVI II AP (refer to “Setup Wizard” on page 82 of this manual for instructions).

Advanced Setup

An advanced user may want to customize the setup beyond the parameters provided by the

Setup Wizard.

Steps to Set Up SVI II AP

To set up the SVI II AP:

1. Configure the SVI II AP.

 Read and Set Configuration Parameters

2. Calibrate the SVI II AP.

a. Run Find Stops or Manual Find Stops

b. Run AutoTUNE

c. View Calibration Parameters

Before making any configuration or calibration changes ValVue must be in

Setup mode.

NOTE

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 659 660

Commentaires sur ces manuels

Pas de commentaire

GE MN-ValVue-v2-8-IOM Manuel de service Page 57

Commentaires sur ces manuels

Produits connexes et manuels pour Mesure, test et contrôle GE MN-ValVue-v2-8-IOM