GE MN-ValVue-v2-8-IOM Manuel de service télécharger pdf (Page 493)

100

101

493

Configure Event Notification Tab

Configure



Tertiary Analog Channel Saturated: Check to set an event when the electrical

limits established by the field device are exceeded for the corresponding analog

channel.

 Quaternary Analog Channel Saturated: Check to set an event when the electrical

limits established by the field device are exceeded for the corresponding analog

channel.

 Quinary Analog Channel Saturated: Check to set an event when the electrical

limits established by the field device are exceeded for the corresponding analog

channel.

 Simulation Active: Check to set an event when a simulation runs.

 Non-Volatile memory failure: Check to set an event when there is a non-volatile

memory failure.

 Volatile memory failure: Check to set an event when there is a volatile memory

failure.

 Watchdog reset executed: Check to set an event when a watchdog timer resets.

 Voltage conditions out of range: Check to set an event when device voltage goes

out of range. This is set when the device is in battery powered mode and the

battery state reaches Critical.

 Environmental conditions out of range: Check to set an event when conditions go

out of range. This is set when unit temperature is below -54 °C or above +89 °C.

 Electronic failure: Check to set an event when there is any electronics failure.

 Subdevice list changed: Check to set an event when any additions or deletions

occur to the subdevice list.

 Duplicate master detected: Check to set an event when a second master is

detected on the network.

 Capacity Denied: Check to set an event when a the device has been denied a

request for network capacity (bandwidth) to perform a function. Check the burst

mode settings ( “Configure Wireless Tab”).

 Bandwidth allocation pending: Check to set an event when a gateway requested

bandwidth allocation is made but not yet completed.

 Block transfer pending: Check to set an event when a block transfer is in process.

Block transfers are used for asset management or large data transfers.

Device-Specific Event

Mask 1 and 2

Fld dev stat

Use this tab to enable/disable various events so that they are active for alarming.

The alarms are reflected on the “Event Status Subtab” as screen LEDs.

Check to set an event when the device-specific item is out of range.

1 2 ... 488 489 490 491 492 493 494 495 496 497 498 ... 659 660

Commentaires sur ces manuels

Pas de commentaire

GE MN-ValVue-v2-8-IOM Manuel de service Page 493

Commentaires sur ces manuels

Produits connexes et manuels pour Mesure, test et contrôle GE MN-ValVue-v2-8-IOM